ㆍ Two leg, three phase, burst firing Power Controller
TE200A Two leg, three phase, burst firing Power Controller
Ergonomic design
Analog input configured as voltage, current or potentiometer
Burst firing or single cycle firing modes
Input current 4-20mA
Input voltage 0-5Vdc, 0-10Vdc
Nominal current per phase 16-63A at 45°C
The TE200 range is designed for general purpose three phase applications which use three wire resistive or short wave infrared (SWIR) loads. Two of the three phases are switched by the TE200, the third phase being directly connected.
Control performance
The total power controlled in the three phase load (V²) is proportional to the setpoint. Linearity is better than +/- 2% full scale. Stability for +/- 10% supply voltage variation is better than +/- 2% of full scale.
Firing Mode
Single or burst firing with modulation period of 30 cycles at 50% power and 6 seconds at very high and low powers. Zero crossing firing with LED indication of status.
Ideal for:
Heat treatment
Metallurgy
Food processing
Plastics
Environmental temperature control
Mechanical Details
Cut-out dimensions
Click to enlarge
Features
Alarms
No
Controlled Phases
2
Current Limit
No
Diagnostics
No
Digital Comms
No
Firing Mode Burst Firing
Yes
Firing Mode Phase Angle
No
Heater Type Constant Resistance
Yes
Heater Type Inductive/Transformer Coupled
No
Heater Type SWIR
Yes
Heater Type Variable Resistance
No
Input Analogue
Yes
Input Logic
Yes
Maximum Current (Amps)
63A
Maximum Voltage (Volts)
500V
PLF and/or PLU
No
